sudo systemctl start can also substitute the start above with stop to stop Home Assistant, restart to restart Home Assistant, and ‘status’ to see a brief status report as seen below. sudo systemctl disable start Home Assistant now, use this command. sudo systemctl enable disable the automatic start, use this command. To have Home Assistant start automatically at boot, enable the service.

You need to reload systemd to make the daemon aware of the new configuration. ĮxecStart=/usr/bin/docker run -name=home-assistant-%i -v /home/%i/.homeassistant/:/config -v /etc/localtime:/etc/localtime:ro -net=host homeassistant/home-assistantĮxecStop=/usr/bin/docker stop -t 2 home-assistant-%iĮxecStopPost=/usr/bin/docker rm -f home-assistant-%i If you want to use Docker, the following template should work for you. Now head down to the Next Steps section Docker YOUR_USER should be replaced by the user account that Home Assistant will run as (e.g homeassistant).ĮxecStart=/srv/homeassistant/bin/hass -c '/home/%i/.homeassistant' If Home Assistant install is not located at /srv/homeassistant, please modify the ExecStart= line appropriately. If you’ve setup Home Assistant in virtualenv following our manual installation guide for Raspberry Pi (or the Python installation guide), the following template should work for you. sudo nano -w After text entered, press CTRL-X then press Y to save and exit. If unfamiliar with command-line text editors, sudo nano -w can be used with replaced with the full path to the file. Check with whereis hass for the location.įor most systems, the file is with YOUR_USER replaced by the user account that Home Assistant will run as (normally homeassistant). The following should be noted to modify the template:ĮxecStart contains the path to hass and this may vary. Note, root permissions via sudo will likely be needed. The template below should be created using a text editor. If the preceding command returns the string systemd, continue with the instructions below.Ī service file is needed to control Home Assistant with systemd. If you are unsure if your system is using systemd, you may check with the following command: ps -p 1 -o comm= This includes Ubuntu releases including and after 15.04, CentOS, and Red Hat. Typically, systems based on Fedora, ArchLinux, or Debian (8 or later) use systemd. Newer Linux distributions are trending towards using systemd for managing daemons.

Autostart no root v2.1 download